Infocus IN5134A Manuel D’Utilisation
8
Installation
2.3 Installing the second projector (Set B)
Connecting projectors
To use Intelligent Stack, connect an RS-232 null modem cable between the
CONTROL port of Set A and Set B.
(continued on next page)
NOTE
• KEYSTONE cannot be selected when PERFECT FIT is in use. To
reset both functions, reset PERFECT FIT first.
• Set up the INSTALLATION settings first because the image position may
• Set up the INSTALLATION settings first because the image position may
change. (
Operating Guide
→
SETUP menu
)
2.
Reset the adjustment of KEYSTONE and PERFECT FIT on Set
B.
(
Operating Guide
→
EASY MENU
or
SETUP menu
)
1.
Turn on Set
B.
NOTE
• After turning on Set
B, verify the image of Set B is not significantly
tilted compared to the image of Set
A. If the image is overly tilted, rotate the
elevator feet of Set
B to adjust the angle so that the tilt is just about right.
Setting up Set B
NOTE
• Set the tilt angle of Set
B within 9 degrees of the level line.
Deciding the installation position
Decide the position of Set
B and its projection angle. (
User’s Manual (concise)
→
Arrangement
and
Adjusting the projector’s elevator
)
WARNING ►For IN5142, IN5144, IN5144a and IN5145 only: You can install
the projector in any direction with specified mounting accessories. Consult with
your dealer for that type of installation.