IBM VT670 Manuel D’Utilisation

(See also "Power/Status/Lamp Indicator" on page 

Does not turn on

Will turn off

No picture

Picture suddenly
becomes dark

Color tone or hue is
unusual

Image isn’t square to
the screen

Picture is blurred

Image is scrolling
vertically, horizontally
or both

Remote control does
not work

Indicator is lit or
blinking

Cross color in RGB
mode

• Check that the power cable is plugged in and that the power button on the projector cabinet or the remote

• Ensure that the lamp cover is installed correctly. See page 

• Check to see if the projector has overheated or the lamp usage exceeds 2100* hours (up to 3100* hours : Eco

mode). If there is insufficient ventilation around the projector or if the room where you’re presenting is par-
ticularly warm, move the projector to a cooler location.
* VT575 and VT47: 3100 hours (up to 4100 hours in Eco mode).

• The lamp may fail to light. Wait a full minute and then turn on the power again.
• The lamp has reached the end of its usable life. Replace the lamp.

• Ensure that the Power Management is off. See page 

• Use the VIDEO, the S-VIDEO or the COMPUTER button on the remote control to select your source (Computer,

• Ensure your cables are connected properly.
• Use menus to adjust the brightness and contrast. See page 

• Remove the lens cap.
• Reset the settings or adjustments to factory preset levels using the “Default” in the Menu. See page 

• Enter your registered keyword if the Security function is enabled. See page 

• When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning

on the power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook
PC is turned on after connecting with the projector.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-

saver or power management software.

• See also the next page.

• When one of the following happens, the Lamp mode automatically changes from Normal to Eco.

* When there are no signals (blue or black screen) 

→ To return to the Normal mode, select another available

source.

* When the image is muted using the PIC-MUTE button on the remote control 

→ Press the PIC-MUTE button

again to return to the Normal mode.

* When the room where you' re presenting is particularly warm 

→ Move the projector to a cooler location.

• Check if an appropriate color is selected in "Wall Color". If so, select an appropriate option. See page 

• Adjust "Hue" in "Picture". See page 

• Reposition the projector to improve its angle to the screen. See page 

• Use the Keystone correction function to correct the trapezoid distortion. See page 

• Adjust the focus. See page 

• Reposition the projector to improve its angle to the screen. See page 

• Ensure that the distance between the projector and screen is within the adjustment range of the lens. See

• Condensation may form on the lens if the projector is cold, brought into a warm place and is then turned on.

Should this happen, let the projector stand until there is no condensation on the lens.

• Use the VIDEO, the S-VIDEO or the COMPUTER button on the remote control to select your source (Video, S-

• Adjust the computer image manually with the Horizontal/Vertical in the “Advanced 

→ Page 2”. See page 

• Install new batteries.See page 

• Make sure there are no obstacles between you and the projector.
• Stand within 22 feet (7 m) of the projector. See page 

• See the POWER/STATUS/LAMP Indicator on page 

• Press the AUTO ADJ. button on the projector cabinet or the remote control. See page 

• When “Off” is selected in Auto Adjust, adjust the computer image manually with Clock/Phase in “Advanced 

→

For more information contact your dealer.