Canon WX6000 Manuel D’Utilisation

128

[Password settings]

Disables the projector unless the correct 

password is entered.

MENU > [System settings] > [Other settings] > 
[Password settings]

MENU > [System settings] > [Other settings] > 
[Password settings]

Press the 

OK button to accept your setting 

and then press the 

MENU button or EXIT 

button (WX6000 / SX6000).

• [Off] is the factory default.
• You cannot set [On] unless you have com-

pleted [Register password].

Once you set a password, the password 
entry screen appears at power-on.

Enter a 4 digit password.
For the WUX5000 / WUX4000, the pass-
word can be entered using the [ ] / [ ] / 
[ ] / [ ] buttons. For the WX6000 / 

SX6000, the password can be entered 
using a combination of the numerical but-
tons and the [ ] / [ ] / [ ] / [ ] buttons. 
[ ] / [1], [ ] / [2], [ ] / [3], and [ ] / [4] 
have the same function.
If the password is valid, the projection 
starts. If you enter a wrong password three 
times, the power will be turned off.

• The power is also turned off if no password 

is input for 3 minutes.

HDMI

Component

Digital PC

Analog PC

Off

The projector can be used even if no pass-
word is entered.

On

The projector cannot be used unless you 
enter your password.

T o  C ance l  the  P a ssw ord
Turn off the projector and unplug the power 
plug. 
Hold down the 

MENU button on the side control 

and connect the power plug. Make sure to keep 
holding down the 

MENU button until a beep 

sounds. When the beep sounds, the password 
is canceled. (The entered password is also 
reset.)
To forcibly cancel the password from the remote 
control, in standby state press the 

MENU button 

3 times, then press the 

POWER button.