Canon WX6000 Manuel D’Utilisation

175

Installation Manual

Connecting to a Networ

k

You can turn the projector DHCP function 
on or off. 

MENU > [Network Setting] > [DHCP]

Press the 

OK button to accept your setting 

and then press the 

MENU button or EXIT 

button (WX6000 / SX6000).

• [Off] is the factory default.

Configure the projector TCP / IP settings.

MENU > [Network Setting] > [TCP/IP setting]

When [TCP/IP setting] is selected, the win-
dow shown below appears. Use the 

[

]

 / 

[ ] buttons to select the IP address, then 
press the 

OK button. Next, use the [ ] / 

[ ] buttons to select the digit and the 

[

]

 / 

[ ] buttons to change the value. For the 
WX6000 / SX6000, numbers can be 
entered using the numerical buttons on 
the remote control. Press the 

OK button, 

then set the subnet mask and gateway 
address in the same way. Finally, select 
[Enter].

• The factory defaults are shown below.

IP address

192.168.254.254

Subnet mask

255.255.255.0

Gateway address 0.0.0.0

• Settings cannot be made when [DHCP] 

(

) is [On].

• If an invalid value is entered, the message 

“Invalid entry” appears. If this occurs, 
enter a valid value.

Off

Disables the DHCP function. TCP / IP 
settings are possible.

On

Enables the DHCP function. 
Searches the DHCP server

.

 Because 

the IP address is acquired from the 
DHCP server, it is not necessary to 
enter the TCP / IP settings (IP 
address, subnet mask, gateway 
address).