Canon LV-7295 Manuel D'Instructions

14

To ensure safe operation, please observe the following precautions :

  ● Use two (2) AAA type batteries.

  ● Always replace batteries in sets.

  ● Do not use a new battery with a used battery.

  ● Avoid contact with water or liquid.

  ● Do not expose the remote control unit to moisture or heat.

  ● Do not drop the remote control unit.

  ● If the battery has leaked on the remote control unit, carefully wipe the case clean and install new batteries.

  ● Risk of an explosion if battery is replaced by an incorrect type. 

  ● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery 

compartment lid.

Install new batteries 

into the compartment.

Replace the 

compartment lid.

For correct polarity (+ 

and –), be sure battery 

terminals are in contact 

with pins in compartment.

Point  the  remote  control  unit  toward  the  projector 

(Infrared  Remote  Receiver)  when  pressing  the  buttons. 

Maximum operating range for the remote control unit is 

about 16.4'(5 m) and 60 degrees in front of the projector.

16.4'

(5 m)

30° Remote control unit

30°

The    different  remote  control  codes  (Code  1–Code 

)  are  assigned  to  this  projector.  Switching  the  remote 

control  codes  prevents  interference  from  other  remote 

control units when several projectors or video equipment 

next  to  each  other  are  operated  at  the  same  time. 

Change  the  remote  control  code  for  the  projector  first 

before  changing  that  for  the  remote  control  unit.  See 

"Remote control" in the Setting Menu on page 59.

Press and hold the MENU and IMAGE buttons for more 

than  five  seconds  to  switch  between  the 

Code  1  and 

Code 2. The initial code is set to Code 1.