Christie Digital Systems 104-012101-XX Manuel D’Utilisation
Stacking Frame Installation Instructions
013-100342-01 (Rev.1) (08/06)
2 of 12 pages
Warnings
Christie stacking hardware is required to prevent the top projector from sliding
off the stack. Failure to incorporate this hardware may cause injury or death.
This procedure must only be performed by a qualified service technician.
The frame is designed to support a maximum stacking capacity of three
projectors. Always stack before hoisting.
Never attempt to physically carry a stack of projectors. Always follow the
Hoisting Procedure, outlined on page 6.
Use metric hardware only. Never force incompatible threads.
Always use all rigging points.
The stacking frame handles have a maximum load capacity of 360 lbs.
The projectors can be stacked and hoisted in either an upright or inverted
position. Do not mix orientations in a stack (i.e. inverted and upright).
All rigging must be in compliance with applicable local safety codes.
Only licensed riggers should perform the procedures outlined in this document.
Figure 1. Projector with Stacking Frame
OFFICIALLY RELEASED
Document Control
September 8, 2006