Christie Digital Systems 103-009100-01 Manuel D’Utilisation
69
Troubleshooting
Before calling your dealer or service center for assistance, check the items below once again.
–Make sure you have properly connected the projector to peripheral equipment as described on pages 22–24.
–Make sure all equipment is connected to AC outlet and the power is turned on.
–When the projector does not project an image from the connected computer, restart the computer.
–Make sure all equipment is connected to AC outlet and the power is turned on.
–When the projector does not project an image from the connected computer, restart the computer.
Appendix
Problem:
– Solutions
No power
– Plug the power cord of the projector into the AC outlet.
– See if the POWER indicator is lit.
– Wait 90 seconds after the projector is turned off when turning the
– See if the POWER indicator is lit.
– Wait 90 seconds after the projector is turned off when turning the
projector back on. The projector can be turned on after the POWER
indicator stops blinking. See on page 26.
indicator stops blinking. See on page 26.
– Check the WARNING TEMP. indicator. If the WARNING TEMP.
indicator is blinking, the projector cannot be turned on. See page 67.
– Check the projection lamp. See page 65.
– Unlock the Key lock function for the projector. See page 59.
– Unlock the Key lock function for the projector. See page 59.
Image is out of focus.
– Adjust focus of the projector. See pages 29, 31.
– Provide proper distance between the projector and projection screen
– Provide proper distance between the projector and projection screen
See page 20.
– Check the projection lens to see if it needs cleaning. See page 68.
– Moving the projector from a cool to warm place may result in moisture
– Moving the projector from a cool to warm place may result in moisture
condensation on the projection lens. In such cases, leave the projector
off and wait until condensation evaporates.
off and wait until condensation evaporates.
No image
– Check the connection between your computer or video equipment and
the projector. See pages 22–24.
– See if the input signal is correctly output from your computer. Some
laptop computers may need to change the setting for monitor output
when connecting to the projector See your computer’s instruction
manual for the setting.
when connecting to the projector See your computer’s instruction
manual for the setting.
– It takes about 30 seconds to display an image after turning on the
projector.
– See if the selected system is corresponding with your computer or
video equipment. See pages 36, 38.
– Select correct input source once again through menu operation. See
page 35.
– Make sure the temperature is not out of the specified Operating
Temperature (
41 ˚F–95 ˚F [5 ˚C–35 ˚C])
.
Image is Left/Right reversed.
– Check the Ceiling/Rear function. See page 50.
Image is Top/Bottom reversed.
– Check the Ceiling function. See page 50.
No sound
– Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the Volume + button. See page 30.
– Press the Mute button. See page 30.
– Adjust the audio source.
– Press the Volume + button. See page 30.
– Press the Mute button. See page 30.
LX380-380L-450 User Manual
020-000061-01 Rev. 1 (07/08)