Toshiba B-SX8T Manuel D’Utilisation
2. SYSTEM MODE
EO13-33002
2.1 Self-diagnostic Test
2- 4
2.1.1 Printing Mode Selection
While “PRT TYPE TRANSFR” is displayed on the LCD, press the [PAUSE] key. The type of printing mode
can be selected:
“TRANSFR” (Thermal transfer) or “DIRECT” (Thermal direct).
After selecting the printing mode to be used, press the [PAUSE] key.
can be selected:
“TRANSFR” (Thermal transfer) or “DIRECT” (Thermal direct).
After selecting the printing mode to be used, press the [PAUSE] key.
NOTE: When using the ribbon, be sure to select “Thermal Transfer”. When using the thermal media, be sure to
select the “Thermal Direct”.
2.1.2 Dispensing Mode Selection
When “TYPE[S] NO CUT” is displayed, press the [PAUSE] key. The type of dispensing mode can be
selected:
“[S] NO CUT” (Batch issue) or “[C] WITH CUT” (Cut issue)
After selecting the dispensing mode to be used, press the [PAUSE] key.
selected:
“[S] NO CUT” (Batch issue) or “[C] WITH CUT” (Cut issue)
After selecting the dispensing mode to be used, press the [PAUSE] key.
NOTE: When using the cutter module, be sure to select “[C] WITH CUT”. When the cutter module is not
installed, be sure to select “[S] NO CUT”.
<1>DIAG. Vx.x
PRT TYPE TRANSFR
PRT TYPE TRANSFR
<1>DIAG. Vx.x
PRT TYPE DIRECT
PRT TYPE DIRECT
Thermal transfer: When transparent ribbon is used.
Thermal direct: When thermal paper is used.
[RESTART]
[FEED]
<1>DIAG. Vx.x
TYPE[S] NO CUT
TYPE[S] NO CUT
<1>DIAG. Vx.x
TYPE[C] WITH CUT
TYPE[C] WITH CUT
[S] NO CUT (Batch issue): To issue media in batch
mode.
mode.
[C] WITH CUT (Cut issue): When an optional cutter
module is installed.
module is installed.
[RESTART]
[FEED]
<1>DIAG. Vx.x
PRT TYPE NO TRAN
PRT TYPE NO TRAN
Thermal transfer: When non-transparent ribbon is used.