Toshiba B-SX8T Manuel D’Utilisation
2. SYSTEM MODE
EO13-33002
2.2 Parameter Setting
2-30
2.2.22 Input Prime Selection
This parameter is to choose whether to enable a reset operation when INIT signal is ON.
Normally, when the printer receives a reset request signal (nInit signal) from the host via Centronics
interface, the printer will be reset and turn to the idle state.
When the INPUT PRIME parameter is set to OFF, the printer is reset but does not turn to idle.
When this parameter is set to ON, the host sends an INIT signal and the printer turns to idle each time the
printer is turned on. If you would like to avoid this processing, set this parameter to OFF.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Input Prime, press the [PAUSE] key.
Normally, when the printer receives a reset request signal (nInit signal) from the host via Centronics
interface, the printer will be reset and turn to the idle state.
When the INPUT PRIME parameter is set to OFF, the printer is reset but does not turn to idle.
When this parameter is set to ON, the host sends an INIT signal and the printer turns to idle each time the
printer is turned on. If you would like to avoid this processing, set this parameter to OFF.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Input Prime, press the [PAUSE] key.
2.2.23 Expansion I/O Interface Type Selection
This parameter is to choose a type of the Expansion I/O interface operating mode.
This parameter should be set depending on the expansion I/O control specification of the device to be
connected via the expansion I/O interface. For details, refer to the External Equipment Interface
Specification.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting an Expansion I/O Interface type, press the [PAUSE] key.
This parameter should be set depending on the expansion I/O control specification of the device to be
connected via the expansion I/O interface. For details, refer to the External Equipment Interface
Specification.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting an Expansion I/O Interface type, press the [PAUSE] key.
<2>PARAMETER SET
INPUT PRIME OFF
INPUT PRIME OFF
INPUT PRIME OFF
INPUT PRIME ON
[RESTART]
[FEED]
Unavailable
Available
<2>PARAMETER SET
EX.I/O TYPE1
EX.I/O TYPE1
EX.I/O TYPE1
EX.I/O TYPE2
[RESTART]
[FEED]
TYPE1: Standard mode
TYPE2: Inline mode