Toshiba B-SX8T Manuel D’Utilisation

1. INTRODUCTION

EO13-33002

(Revision Date: Jul. 24, 2008)

1.1 Key Operation Flow

1- 1

1. INTRODUCTION

This document describes key operations using the keys and LCD display on the printer that you can operate
on a printer alone. Key operations are performed in the following four printer setting modes:

•

Online mode where a pause, reset, automatic threshold setting, etc. are performed.

•

Download mode where a firmware downloading is performed.

•

System mode for service personnel where a self-diagnosis, printer parameter settings, RAM clear, IP
address setting etc. are performed.

•

System mode for end user where a self-diagnosis, printer parameter settings, fine adjustment, etc.,
which are same functions as those in System mode for service personnel, are performed.

NOTE: This document uses the B-SX8T for examples of the display.

1.1 Key Operation Flow

Download mode

Power OFF

Feed gap sensor automatic threshold setting

Black mark sensor threshold setting

Turn the power on.

While holding down the [FEED] and [RESTART]
keys, turn the power on.

While holding down the
[FEED] and [PAUSE]
keys, turn the power on.

[FEED] key

[RESTART] key

Hold down the [PAUSE] key
for a few seconds.

Hold down the [RESTART] key
for a few seconds.

[FEED] key or [RESTART] key

[PAUSE] key

Online

Feeds one label.

Pause

• Self-test
• Parameter setting
• Fine adjustment
• Test print
• Sensor adjustment
• RAM clear
• IP Address setting
• Basic setting
• For factory
• RFID Module Setting

• Self-test
• Parameter setting
• Fine adjustment
• Test print

While holding down the [FEED],
[RESTART], and [PAUSE] keys,
turn the power on.

• Reset
• Parameter Setting
• Fine adjustment
• Dump mode
• Expand mode (Basic expansion mode)
• Automatic calibration mode
• LAN Enable/Disable
• RTC Setting

System mode for end users

System mode for service personnel

Online mode