Toshiba TRST-56 SERIES Manuel D’Utilisation
4. SET UP PROCEDURE
EO1-13016
4.1 Requirements for Operation
4- 1
4. SET UP PROCEDURE
4.1 Requirements for Operation
This printer has the following requirements:
Serial interface Type
•
The TOSHIBA TEC POS terminal to be connected must have a serial port.
•
To communicate with the TOSHIBA TEC POS terminal, an RS-232C interface cable is required.
RS-232C cable........ 25 pins
Parallel Interface Type
•
The TOSHIBA TEC POS terminal to be connected must have a Centronics parallel port.
•
To communicate with the TOSHIBA TEC POS terminal, a Centronics interface cable is required.
Centronics cable ..... 36 pins
Interface Cables
For the serial interface model, use the CBLST-50-2-QM serial printer cable available from TOSHIBA
TEC or equivalent. For the parallel interface model, use the Centronics cable which satisfies the
following pin configuration and the specification of the connector.
To prevent the emission and receipt of electrical noise, the interface cable must meet the following
requirements:
•
Fully shielded and fitted with metal or metalized connector housings.
•
Kept as short as possible.
•
Should not be tightly bundled with the power cord.
•
Should not be tied to power line conduits.
RS-232C cable pin configuration
POS terminal side
Printer side
D-SUB 9-pin female
D-SUB 25-pin male
PIN No.
Signal
PIN No.
Signal
Case
FG
1
FG
2
RXD
2
TXD
3
TXD
3
RXD
8
CTS
4
RTS
4
DTR
6
DSR
5
GND
7
GND
6
DSR
20
DTR
Centronics cable pin configuration
POS terminal side
Printer side
D-SUB 25-pin male
IEEE1284-B receptacle
PIN No.
Signal
PIN No.
Signal
1
/STROBE
1
/STROBE
2-9
PD1-8
2-9
PD1-8
10
/ACK
10
/ACK
11
BUSY
11
BUSY
12
PERROR
12
PERROR
13
SELECT
13
SELECT
14
/AUTOFD
14
/AUTOFD
16
/INIT
31
/INIT
15
/FAULT
32
/FAULT
17
/SELECTIN
36
/SELECTIN
18-25
GND
19-30
GND
15-18
N.C.
33-35
N.C.
NOTE: For details of the interface cable, contact your nearest TOSHIBA TEC representative.