Tally Genicom 6600 Manuel D’Utilisation
188
Chapter
9
PGL Commands
Table 24. CREATE LOGO Mode Command
Field
Function
Option/Modifier Selections
LOGO;
Initiates Create LOGO Mode.
Enter the current Special Function Control
Character followed by LOGO, then end the
entry with the parameter delimiter.
Character followed by LOGO, then end the
entry with the parameter delimiter.
Name;
Enter the name of the Logo in this
field.
field.
LOGO names are allowed a maximum of
eight characters. The follownig ASCII
characters may be used in form names:
eight characters. The follownig ASCII
characters may be used in form names:
•
Upper and lower-case A - Z
(HEX 41 - 5A and 61 - 7A)
•
Number 0 - 9 (HEX 30 - 39)
•
Dollar sign $ (HEX 24)
•
Percent Sign % (HEX 25)
•
Dash - (HEX 2D)
•
At sign @ (HEX 40)
•
Braces { } (HEX 7B and 7D)
•
Parens ( ) (HEX 28 and 29)
•
Tilde ~ (HEX 7E)
•
Single quotes ‘ ‘ (Hex 60 and 27)
•
Exclamation point ! (HEX 21)
•
Pound sign # (HEX 23)
•
Amersand & (HEX 26)
NOTE: Make sure your LOGO name is
not identical to one that is already
stored in memory. the new LOGO
will replace the old LOGO if this
happens.
stored in memory. the new LOGO
will replace the old LOGO if this
happens.
VL;
Vertical size of the Grid at 72 DPI.
Enter a vlue from 1-252, followed by the
parameter delimiter. Do not enter an
amount larger than necessary to print the
Logo.
parameter delimiter. Do not enter an
amount larger than necessary to print the
Logo.
HL
Horizontal size of the Grid at 60
DPI.
DPI.
Enter a vlue from 1-240, followed by the
parameter delimiter. Do not enter an
amount larger than necessary to print the
Logo.
parameter delimiter. Do not enter an
amount larger than necessary to print the
Logo.
Row#
Specifies which row in the Grid is
being defined for printing dots.
being defined for printing dots.
Enter each row that will be printed on a
separate line, followed by the parameter
delimiter. rows in the Grid are numbered
sequentially from top to bottom of the Grid.
separate line, followed by the parameter
delimiter. rows in the Grid are numbered
sequentially from top to bottom of the Grid.