Canon iPF825 Manuel D’Utilisation

 

Status

Corrective Action

An error message is displayed during printing.

Check the error message and take action as necessary.
(See "

The last portion of roll paper was used during a print job,
and paper could not be advanced because the trailing edge
is taped to the roll.

Remove the used roll and insert a new roll.

Status

Corrective Action

The leading edge of the roll paper
was cut to straighten it.

This operation is normal.
The printer cuts the leading edge of the roll to straighten it and ejects the scraps
when Trim Edge First in the printer menu is On or when Trim Edge First is
Automatic and the leading edge is slanted. The printer is ready to print after this
initial preparation.
When Off is selected under Trim Edge First, the edge is not cut and scraps are
not removed.

The Printhead nozzles are clog-
ged.

Print a test pattern to check the nozzles and make sure the Printhead is in good
condition for printing.

Clean the Printhead if the nozzles are clogged.

A print job was received from an
incompatible printer driver.

Use the correct imagePROGRAF printer driver for the printer and try printing
again.

The printer has received print data
that includes HP RTL commands
when Auto Rotate is On.

Set Auto Rotate to Off before attempting to print again.

The printer is damaged.

Contact your Canon dealer for assistance.

Troubleshooting 

 The printer stops during a print job 

An error message is shown on the Display Screen

iPF825