Xerox FS-C8008DN Manuel D’Utilisation

3-38

6

66

6

Press the Z key. One of the following menus is indicated. To change settings for the 
item, press the ENTER key. Use the U or V key to change the value or selection.

7

77

7

Activate the appropriate protocol that is required to connect the printer to the 
network. To activate a protocol, let the protocol displayed, press the ENTER key, 
press the U or V key to change from Off to On, and press the ENTER key.

8

88

8

Press the MENU key. The display returns to Ready. You can print a network status 
page to confirm that the IP address, subnet mask address, and the gateway address 
have been properly set. To print a network status page, see 

 which follows.

>NetWare       >

  On

Set this item to 

On

 when you connect to a network 

using NetWare. In submenu (>), frame mode can be 
selected from Auto, 802.3, Ethernet II, 
802.2

, and 802.3SNAP.

>TCP/IP        >

  On

Set this item to On when you connect to a network 
using TCP/IP. Submenu (>) has items including 
DHCP, IP address, subnet mask address, and gate-
way address. To resolve IP address for the network 
card, see 

  below.

>EtherTalk

  Off

EtherTalk must be activated (On) for networking 
with Macintosh computers.

>Network Status

 Page   Off

When the item is set to On, the printer prints out a net-
work status page when it prints the printer status. See