FARGO electronic 76502 Manuel D’Utilisation

83

The PrimeraPro Color Printer has an 8-position
DIP switch located on the rear panel next to the
parallel input port. These switches define a
number of printer functions. The factory default
settings for the switches are in the ÒupÓ or ÒoffÓ
position. These  settings are adequate for most
applications.

To change the settings, use a pointed (but not
sharp) object such as a pen or pencil. Turn the
printerÕs power switch on and off to initialize the
changes.

The tables below list all possible switch settings on
the PrimeraPro Color Printer. 

The PrimeraPro Color Printer can be set for two
basic types of ribbons and for two basic types of
page information: color or monochrome. The
switch settings described here allow you to
optimize your printer for a minimum amount of
ribbon waste, depending upon which type of
printing you do most often.

If you are going to use only color ribbon, leave

SW1 off. If you are going to use only monochrome
ribbon or both color and monochrome ribbon, turn
SW1 on. Refer to the table below.

Printer Configuration

OFF

Configuration #1

(FACTORY SETTING)

ON

Configuration #2

Text Mode

OFF

Disabled

(FACTORY SETTING)

ON

Enabled

Not Used

(FACTORY SETTING IS OFF)

Not Used

(FACTORY SETTING IS OFF)

In configuration #1, when color page

information is sent to the printer it will print
normally.  However, when monochrome page
information is sent to the printer, and a color
ribbon is installed, the printer will advance the
ribbon to a color panel which is not yellow before
printing.  When monochrome information is sent
to the printer, and a monochrome ribbon is