Epson S50675 Manuel D’Utilisation
Problem Solver
230
Printing does not stop when the roll ends
Removing jammed media
Follow the steps below to remove jammed media.
1. Open the front cover.
2. Turn off the printer.
If a message is displayed and the printer will not turn off, unplug both power cables.
3. Move the media holding plates out of the way.
o
Is the media too thick or too thin?
Check the media specifications to determine whether it can be used in the printer. See “Supported Media” on page 235.
If you are using a software RIP, contact the manufacturer for information on the settings and media that can be used.
o
Is Media Suction set too high?
Reduce Media Suction. See “Customize Settings” on page 204.
o
Is the item for having the printer detect the end of the media set to Off?
If Advanced Settings - Tension Measurement in media settings or Media End Check in the Printer Setup menu is set to Off,
the end of the media cannot be detected.
the end of the media cannot be detected.
c
Caution:
Be careful not to trap your hands or fingers when opening or closing the front cover. Failure
to observe this precaution could result in injury.
Be careful not to trap your hands or fingers when opening or closing the front cover. Failure
to observe this precaution could result in injury.
Important:
Cease use of the printer if the media holding plates are deformed. Continued use could
damage the pressure rollers or print head.
Cease use of the printer if the media holding plates are deformed. Continued use could
damage the pressure rollers or print head.