Epson S50675 Manuel D’Utilisation
Problem Solver
233
Heaters turn off or the optional additional print drying system stops
The control panel display keeps turning off.
The red light is on inside the printer.
White powdered stains are detected on the sides of the auto take-up reel unit.
o
The pre-, platen, and after heaters will turn off if no print job is received for some time and no error occurs. The time before the
heaters turn off automatically can be selected using the Heat Off Timer option in the setup menu. See “The Printer Setup
Menu” on page 208.
heaters turn off automatically can be selected using the Heat Off Timer option in the setup menu. See “The Printer Setup
Menu” on page 208.
The heaters will be reactivated when a print job is received, the media loading lever is used, or another operation involving
printer hardware is performed.
printer hardware is performed.
The high-speed print drying system is included with the S50675.
o
Is the printer in sleep mode?
The printer enters sleep mode when the Heat Off Timer expires and the heaters turn off. The time before the heaters turn off
can be selected in the Printer Setup menu. See “The Printer Setup Menu” on page 208.
can be selected in the Printer Setup menu. See “The Printer Setup Menu” on page 208.
The heaters will be reactivated and sleep mode will end when a print job is received, the media loading lever is used, or
another operation involving printer hardware is performed.
another operation involving printer hardware is performed.
o
This is not a failure.
The red light is a sensor and normally stays on inside the printer.
o
See the following sections and clean the part.