Epson U230 Manuel D’Utilisation

Your printer has inch-type hexagonal lock screws installed. If your interface cable requires 
millimeter-type screws, replace the inch-type screws with the enclosed millimeter-type 
screws using a hex screwdriver (5 mm).

3. If your interface connector has a grounding wire, attach it to the printer using the screw 

labeled FG.

4. Connect the other end of the interface cable to the host PC.

1. Connect the interface cable connector to the interface connector on the connector panel.

2. Close the tabs on both sides of the connector to lock it.

3. If your interface cable has a grounding wire, attach it to the printer using the screw labeled 

FG.

4. Connect the other end of the interface cable to the host PC.

Be sure to use the same settings of the DIP switches as the parallel interface. Set DIP switch 2-4 (# 
31 reset signal) On. 

1. Attach a locking wire saddle as shown in the figure below.

2. Pass the USB cable through the locking wire saddle as shown in the figure.