Epson LX-86TM Manuel D’Utilisation

Can’t deactivate paper-out sensor

Computer systems that monitor

with DIP switch l-5 or ESCape

printer cable pin 12 will ignore

"8".

both 

ESCape “8” and the setting

of switch l-5. These systems will
stop the printing when no paper

is in contact with the paper-end
detector (a small switch located
beneath the platen). Certain prin-

ter cables are designed to over-
come this problem, or you can

use 

a longer page as a backing

sheet.

When the LX-86’s beeper sounds, it usually indicates that the

printer is out of paper. The beeper can also be sounded by any
program that sends the ASCII 7 code and by certain error conditions

in the printer itself.

If the printer beeps and stops printing when it is not out of paper,

turn the printer off and check to see if the paper is loaded correctly. If
the paper is loaded correctly, turn the printer back on and try to print

again. If the printer beeps and does not print again, take it to a

qualified service person.

The LX-86 has a special feature that makes it easy for experienced

printer users to find the causes of problems. Called the data dump

mode, it gives a printout of exactly what codes reach the printer.

Turn on this mode by turning on the printer while holding

down the FORM FEED and LINE FEED buttons at the same time.
The printer responds by printing the words “Data Dump Mode. ”
Then, when you run a program, either an applications program or

one you have written in any programming language, the LX-86
prints one or more lines. Each line has three parts: the line number

(four digits), the hexadecimal codes (up to 

16 numbers), and the

guide section (16 characters at the end of each line except the last).