Epson DFX-9000 Manuel D’Utilisation
108
Problem Solver
Note:
To temporarily stop the self test, press the Pause button. To resume
the test, press the Pause button again.
To temporarily stop the self test, press the Pause button. To resume
the test, press the Pause button again.
3. To end the self test, press the Pause button to stop printing.
Tear off the page if necessary, and then turn off the printer.
c
Caution:
Do not turn off the printer while it is printing the self test.
Always press the Pause button to stop printing and then
turn off the printer.
Do not turn off the printer while it is printing the self test.
Always press the Pause button to stop printing and then
turn off the printer.
Printing Hex Dump
If you are an experienced user or a programmer, you can print a
hexadecimal dump to isolate communication problems between
the printer and your software program. In hex dump mode, the
printer prints all data it receives from the computer as
hexadecimal values.
hexadecimal dump to isolate communication problems between
the printer and your software program. In hex dump mode, the
printer prints all data it receives from the computer as
hexadecimal values.
Note:
The Hex Dump feature is designed for use with DOS-based PC.
The Hex Dump feature is designed for use with DOS-based PC.
Follow these steps to print a hex dump:
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. To enter hex dump mode, turn on the printer while holding
down the Top of Form and LF/FF Load buttons.