Epson DFX-9000 Manuel D’Utilisation

2

2

2

2

2

2

2

2

2

2

2

2

The top-of-form position is the position to which the printer feeds 
the paper when it loads it or performs a form feed. This position 
is important because it determines where the printing begins on 
each page. If the printing is too high or low on the page, you can 
adjust the top-of-form position either permanently or temporarily 
depending on how you use the Top of Form button.

❏ When you want to permanently change the top-of-form 

position, you enter the top-of-form mode using the Top of 
Form control panel button. The printer remembers the new 
top-of-form position even after the printer is turned off, reset, 
or initialized. (The printer remembers separate top-of-form 
positions for the front and rear tractors.)

❏ When you want to temporarily change the top-of-form 

position, you adjust the position using the Micro Feed 
buttons during pause status without entering top-of-form 
mode. The printer remembers the temporary top-of-form 
position until the next time you load paper, switch tractors, 
or turn off the printer. 

You can set the top-of-form position from 4.2 mm (0.17 inch) to 
33.9 mm (1.33 inch) below the top edge of the paper. The factory 
setting is 8.5 mm (0.33 inch).

Follow the steps below to reset (permanently change) the 
top-of-form position.