Genesis Advanced Technologies GENESIS 5.3 Manuel D’Utilisation

Page de 24
 
 
Genesis 5.3 Owners Manual Ver 2.2 
 
8
~ÄëçäìíÉ=ÑáÇÉäáíó
Tuning the system 
Two channel stereo music is the best way to begin your setup 
procedure. We suggest that multi-channel and video sources be 
used only after you have setup the system to properly reproduce 
music. The room in which the G5 is placed would probably be the 
greatest influence on the sound of the loudspeaker. 
Since we do not live in anechoic chambers, at Genesis, we do not 
design our loudspeakers to work perfectly in a perfectly damped 
room. The amount of hard/soft and absorbent/reflecting surfaces will 
affect the sound of the speakers tremendously.  
A room with solid concrete or brick walls, floors and ceiling will have 
much more bass than if the walls were made of plasterboard, with a 
suspended floor and false ceiling. An over-stuffed leather sofa will 
absorb different frequencies to different extents from a light fabric-
covered armchair. So, you may even find that you will want to re-
tune your system when you change the furnishings in the room. 
We suggest that you start your tuning with a single vocal with simple 
instrumental accompaniment because the sound of the human voice 
is more easily recognizable than many instruments and is the least 
complex sound to deal with. A male voice, or a low female voice is 
the easiest to start working with. 
Adjusting the Bass Gain 
Leave the low pass filter alone for the moment, as it should remain 
set at approximately 90 Hz. This control will be addressed later. 
Turn the gain control of the woofer amplifier up or down until the 
voice sounds correct. Whatever controls you use, turn them up and 
down only a little at a time. It is easy to turn it up or down too much. 
However, the 12 o’clock position is only the starting point. Different 
room construction and size will greatly influence the setting of the 
bass gain.  
If your room has “lossy” walls instead of solid brick or concrete walls, 
you may find that the bass settings may need to be higher. If you 
have a sealed room with no bass loss, the bass gain may be set as 
low as 2 or 3. 
Concentrate on the mid-bass regions (as opposed to the very low 
bass in your recording) to achieve a natural blend. The voice and the