Epson TM-P60 Manuel D’Utilisation
2-22
Setup
Rev. D
Note:
Change the SSID from default and define WEP key to secure your wireless LAN.
We recommend to define WEP key as 128bit, Hexadecimal to secure security.
This printer doesn’t support the blank SSID ““(any). Enter one character into the SSID at least.
Ad-Hoc mode is for default value only. See “Q 1. Can I use the TM-P60 in the Ad-Hoc mode?” (page
E-1) for detail.
E-1) for detail.
5. Click the “TCP/IP” tab.
6. Set the following items for the wireless LAN installed in the printer.
•
Method for specifying the IP address
•
IP address setting (IP address, Subnet Mask, Default gateway)
When you select the method “Auto,“ you can omit the IP address setting.
When you select the method “Auto,“ you can omit the IP address setting.
7. Click the “OK” button. (This utility shows a dialog box, follow the message.)
8. A dialog box is shown as following, click the OK button without entering any password.
Note:
This printer doesn’t have any password at shipped. When you registered a password into the printer,
you have to enter it on the dialog box. For setting password, see “B.2.4.1 password” (page B-28).
you have to enter it on the dialog box. For setting password, see “B.2.4.1 password” (page B-28).
9. The changin is enabled after the utility shows you “finished” message.