Printek 4503 Manuel D’Utilisation
Printek Emulation
Page 7-4
Character Size
Set Character Spacing
ESC SP n
Sets character spacing in decipoints (n/720 of an inch). Overrides the "CPI:" value in
the "Setup: FORM" menu. Supported values are shown in the following table.
the "Setup: FORM" menu. Supported values are shown in the following table.
n
Character Size
72
10 cpi
60
12 cpi
54
13.3 cpi
48
15 cpi
43
16.74 cpi
42
17.14 cpi
36
20 cpi
Example: The following escape sequence will select 10 cpi character spacing.
Escape Sequence:
ESC
SP
72
Hexadecimal:
1B
20
48
Double-Wide Mode
ESC W
n
Selects double-wide mode for n=1, or cancels for n=0. Double-wide mode doubles
the width of all characters, but does not affect character height. ESC S 3 may be used
to select double-high mode.
the width of all characters, but does not affect character height. ESC S 3 may be used
to select double-high mode.
Example: The following escape sequence will select double-wide mode.
Escape Sequence:
ESC
W
1
Hexadecimal:
1B
57
31
Select Script Modes
ESC S n
Selects normal character height for n=0, subscript mode for n=1, superscript mode for
n=2, or double-high mode for n=3. This is shown in the following table.
n=2, or double-high mode for n=3. This is shown in the following table.
n
Script Mode
0
Script modes off
1
Subscript
2
Superscript
3
Double high
Subscript mode will print characters about half the normal height in the bottom half
of the normal character cell. Superscript mode will print characters about half the
normal height in the top half of the normal character cell. Double-high mode doubles
of the normal character cell. Superscript mode will print characters about half the
normal height in the top half of the normal character cell. Double-high mode doubles