Printek 4503 Manuel D’Utilisation
Page B-1
PRINTING BASIC BAR CODES
Introduction
This section describes the control codes and escape sequences comprising bar code
emulation. This emulation may be selected by specifying "Mode: Bar Codes" in the
"Setup: INTERFACE" menu, or via software with the ESC ESC 3 sequence. While
this emulation is selected, control codes and escape sequences from other emulations
are not available.
emulation. This emulation may be selected by specifying "Mode: Bar Codes" in the
"Setup: INTERFACE" menu, or via software with the ESC ESC 3 sequence. While
this emulation is selected, control codes and escape sequences from other emulations
are not available.
Control codes and escape sequences are used to control printer operation. An ASCII
control code is a single character in the range 00 hex through 1F hex, and 7F hex.
The ESC (Escape) control code (1B hex) is used to introduce character strings called
escape sequences, which provide an extension of the commands available with ASCII
control codes.
control code is a single character in the range 00 hex through 1F hex, and 7F hex.
The ESC (Escape) control code (1B hex) is used to introduce character strings called
escape sequences, which provide an extension of the commands available with ASCII
control codes.
The bar code interface was designed to primarily use printable ASCII characters,
instead of relying on control codes and escape sequences. The printable ASCII caret
character "^" is used to introduce most bar code sequences.
instead of relying on control codes and escape sequences. The printable ASCII caret
character "^" is used to introduce most bar code sequences.
Spaces are used when documenting sequences to increase readability. The spaces
within the sequences are for readability only; they are not part of the sequences
themselves. Characters that appear in italics (such as "n") are not sent to the printer
as is; they are used as a place holder indicating that some value must be supplied.
within the sequences are for readability only; they are not part of the sequences
themselves. Characters that appear in italics (such as "n") are not sent to the printer
as is; they are used as a place holder indicating that some value must be supplied.
Multiple character strings without intervening spaces typically represent control
codes. For example, FF is the Form Feed control code (0C hex), not two "F"
characters (46 46 hex). An ASCII Control Code Table with hexadecimal equivalents
is contained in the appendices for your convenience. This may be helpful when
analyzing a hex dump printed by the printer.
codes. For example, FF is the Form Feed control code (0C hex), not two "F"
characters (46 46 hex). An ASCII Control Code Table with hexadecimal equivalents
is contained in the appendices for your convenience. This may be helpful when
analyzing a hex dump printed by the printer.
Please note that bar code emulation is essentially a graphics preprocessor, whose sole
purpose is to print bar codes. It is not possible to print normal text in bar code
emulation. In order to mix text and bar codes, the text must be printed in some other
emulation, before or after the bar codes are printed in bar code emulation.
purpose is to print bar codes. It is not possible to print normal text in bar code
emulation. In order to mix text and bar codes, the text must be printed in some other
emulation, before or after the bar codes are printed in bar code emulation.