Printronix T5000e Series Manuel D’Utilisation
Chapter 2
Bar Code Failures
62
•
You can set the number of bar codes generated by a
bitmapped image that the printer should expect per form by
selecting a value in the “Number of Codes” parameter.
bitmapped image that the printer should expect per form by
selecting a value in the “Number of Codes” parameter.
For more information on choosing a value for the “Number of
Codes” parameter, see “Setting Number Of Bar Codes On A Form”
on page 48.
Codes” parameter, see “Setting Number Of Bar Codes On A Form”
on page 48.
Error Action
Whether the error stems from a bad or missing bar code, the printer
response is the same. The printer response is determined by the
“Validator Action” setting in the VALIDATOR menu:
response is the same. The printer response is determined by the
“Validator Action” setting in the VALIDATOR menu:
1.
Press
to take the printer offline and place the printer in
Menu mode.
2.
If necessary, press
↓ and ↵ at the same time to unlock the
↵ key.
3.
If necessary, press
until “VALIDATOR” displays.
4.
Press
↓ until “Validator Action” displays.
5.
Press + or – to scroll through the choices:
•
Stop
•
Overstrike
•
Retry Form (default)
These options are described in detail below.
6.
Press
↵ to select the desired value.
7.
Press
↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8.
Press PAUSE again to put the printer online.
Stop
If the system detects a bar code failure, the print job stops, the
printer status indicator lamp flashes, the alarm sounds, and the
appropriate error message displays.
printer status indicator lamp flashes, the alarm sounds, and the
appropriate error message displays.
..
.
..
.