Ricoh AP4510 Manuel D’Utilisation
31
3. Configuring the Printer for
the Network
Configuring the Printer for the Network
with the Control Panel
with the Control Panel
After installing the optional Network
Interface Board, configure it for the
network using the printer's control
panel.
Configure the printer for the network
using the printer's control panel.
The following table shows the control
panel settings and their default set-
tings. These are included in the “Host
Interface” menu.
Interface Board, configure it for the
network using the printer's control
panel.
Configure the printer for the network
using the printer's control panel.
The following table shows the control
panel settings and their default set-
tings. These are included in the “Host
Interface” menu.
Reference
For information about configuring
the computer for the network, see
the Network Printing Guide on the
CD-ROM labeled “Operating In-
structions”.
For information about “Host Inter-
face” menu, see “Host Interface
Menu” in the Printer Reference on
the CD-ROM labeled “Operating
Instructions”.
the computer for the network, see
the Network Printing Guide on the
CD-ROM labeled “Operating In-
structions”.
For information about “Host Inter-
face” menu, see “Host Interface
Menu” in the Printer Reference on
the CD-ROM labeled “Operating
Instructions”.
*1
❍ means that this protocol is active.
AAAA
Press
{{{{Menu}}}}.
“Menu” appears on the panel dis-
play.
play.
BBBB
Press
{{{{U
U
U
U}}}} or {{{{T
T
T
T}}}} to display “Host
Interface” menu.
CCCC
Press
{{{{Enter #}}}}.
The following message appears on
the panel display.
the panel display.
Setting Name
Value
IP Address
011.022.033.044
Subnet Mask
000.000.000.000
Gateway Address
000.000.000.000
Network Boot
None
Frame Type (NW)
(Frame type Net-
Ware)
Ware)
Auto
Active Protocol
TCP/IP
❍
*1
NetWare
❍
*1
NetBEUI
❍
*1
AppleTalk
❍
*1
Ethernet Auto
Menu:
Host Interface
Host Interface:
I/O Buffer
Setup-F3_FM.book Page 31 Friday, October 5, 2001 8:27 PM