Sharp AR-C200P Manuel D’Utilisation

Sharp AR-C200P: Accessories  • 172

3. Hold the hard disk drive by the locking handle (1).

4. Insert the handle locating lugs (2) and four locating feet (3) into 

the holes in the main board making sure the hard disk connector 
(4) starts to engage with the socket on the control board.

5. Gently push down on the locking handle (1) making sure the hard 

disk moves forward and fully engages with the socket.

6. Replace the main board and secure it with the two screws.

7. Connect the printer interface cable and power cable, then switch 

on the printer.

8. Print a Menu Map (see page 32) and check that the HDD appears 

at the top of the MenuMap. If it doesn’t, turn the printer off then 
pull the main board back out and reseat the hard disk drive. Turn 
the printer on again and reprint the MenuMap.

9. Engage the Hard Disk Drive in the printer driver(s): see the 

instructions supplied with your Hard Disk Drive.