OKI 110 Manuel D’Utilisation

53  -  C110 User’s Guide

By using the Eject All Toner mode, all toner cartridges can be replaced at the 
same time.

1

Use either operation described below to switch the printer to Eject All 
Toner mode.

! Hold down the Rotate Toner key for more than 10 seconds.

! On the Panel tab of the Remote Panel Utility, select Eject All Toner, 

and then click the Rotate Toner button.

To exit Eject All Toner mode, press the Clear key.

2

Perform the operations described in steps 3 through 11 of “Replacing a 
Toner Cartridge” startin on page 47 to replace the magenta toner 
cartridge.

3

Follow the same procedure to replace the cartridges for the cyan, black, 
then yellow toners.

4

Press the Cancel key to reset the printer and clear the indicator message.

The printer must complete a calibration cycle (less than 2 minutes) 
after a toner cartridge has been replaced. If you open the top or 
front cover before the printer is reset, the calibration stops, then 
starts over again after the cover is closed.