Olivetti 16W Manuel D’Utilisation
26
TWO-SIDED COPYING USING THE
BYPASS TRAY
BYPASS TRAY
To perform manual two-sided copying, follow these steps.
Example:
Copying originals A and B onto each side of one sheet of paper
1
Copy original A.
2
Place original B as shown below.
Vertically-oriented
original:
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
original:
If the original is oriented
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
3
Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Insert the paper all the
way in.
way in.
4
Select the bypass tray with the [TRAY
SELECT] key (
SELECT] key (
), and then press the
[START] key (
).
The copy is delivered to the paper output tray.
1
2
1
Original A Original B
Copy
1
1
Original A
Copied original A
1
1
Original A
Copied original A
2
Original B
2
Original B
• Copies made on the back side of paper
should always be made one sheet at a time
using the bypass tray.
using the bypass tray.
• Straighten curled or wavy paper before
using it. Curled paper may cause misfeeds,
creases, or a poor-quality image.
creases, or a poor-quality image.
2
1
1
Original B
Copied
original A
original A
2
1
1
Original B
Copied
original A
original A
Note