Olivetti P26 Manuel D’Utilisation

Network Configuration> 34

The printer can be configured using TELNET. TELNET requires the 
printer to have a valid IP address configured. If the printer 
already has an IP address configured, skip steps one to three 
below.

The following explanation uses Sun Solaris 2.4 as an example. 
The method of configuring commands may differ between 
workstations. Refer to the workstation’s manual.

Log in as [root]. 

If you do not have Superuser rights, the network manager 
should run the configuration. 

Set a temporary IP Address on the NIC using the ARP 
command.

Example: for IP address 192.168.20.127 and network card 
address 00:80:87:01:00:D2

The Ethernet address (MAC address) is displayed during 
the self-diagnostic test. A temporary address does not 
need to be set if an IP address has already been set.

Use the PING command to confirm the connection with 
the network card.

Example: for IP address 192.168.20.127

If there is no reply, there is a problem with the 
configuration of the IP address (the IP address has been 
already set manually or dynamically), or with the network. 
Reset the network interface card settings to default and try 
to set temporary IP address. If you still have the problem 
after resetting the network interface card, consult the 
network manager.