Olivetti P26 Manuel D’Utilisation

UNIX> 69

The printer supports many protocols such as LPD, FTP, TELNET, 
SNMP and IPP, and works within the UNIX environment.

To use the network card within the UNIX environment, the 
following steps are required:

The first step in installing the network card under UNIX is to set 
up the IP address, Subnet Mask and Gateway. This section 
explains one way to set them up from a UNIX workstation.

The network addresses used in this manual are shown as 
examples only. Network addresses used in your 
installation must be generated for your own network.

Log in as [root] to change the configuration of the printer.

If an incorrect IP address, Subnet Mask or Gateway is 
entered, the network may go down or other damage may 
occur. Check the address with your network manager.

The following explanation uses Sun Solaris 2.8 (Solaris 8) as an 
example. The actual commands may differ between versions of 
UNIX, so refer to the workstation manuals for more information.

Log in as [root] to the workstation

If the printer does not have an IP address already 
assigned, use the arp command to set a temporary IP 
address.

Example: for IP address 192.68.20.127 and network card 
address 00:80:87:01:00:D2