Olivetti P20W Manuel D’Utilisation

Troubleshooting> 87

The network addresses used in this manual are shown for 
example only. Network addresses used in your installation must 
be generated from your own network.

Ensure the printer emulation is set to PS or Automatic.

Turn the printer off for 15 seconds and then on again.

Press the reset button close to the network interface to re-
initialize it.

Turn the printer off for 15 seconds and then on again.

Confirm the network interface is enabled on the printer.

Check there is a response to the PING command.

Check that the network cable is correctly connected and that the 
green LED close to the printer’s network interface is lit. If not, 
change the cable and try again.

Run the Self-diagnostic test.

Check the IP Address, Subnet Mask and Gateway are correct.

Check that the TCP/IP protocol is set to Enable.

Reset the network interface card to factory default settings.

If DHCP, BOOTP and RARP are not used, ensure they have been 
set to Disable.