Hobart ML-29042 Manuel D’Utilisation
Quantum System
Quick-Start Guide - Operator
3
Help
Any time you PRESS [HELP] on the Console, a Help Screen
will appear. It is based on the location of your cursor. If you
have not entered anything and PRESS [HELP], you will get
the Basic Help Screen. If, for example, you TYPE a PLU
and PRESS [HELP], you will get the Product Lookup Help
Screen.
will appear. It is based on the location of your cursor. If you
have not entered anything and PRESS [HELP], you will get
the Basic Help Screen. If, for example, you TYPE a PLU
and PRESS [HELP], you will get the Product Lookup Help
Screen.
Reset
Located on the left side of the scale, to the right of the
Modnet port, is a small button. This is the Reset Button. If
the scale stops responding, use the Reset Button to reset the
scale back to the Start a Run Screen.
Modnet port, is a small button. This is the Reset Button. If
the scale stops responding, use the Reset Button to reset the
scale back to the Start a Run Screen.
To reset the scale, PRESS and hold the Reset Button for 2 to
3 seconds.
3 seconds.
Power Up the System
FIRST TIME ONLY
Normally this is already set up for you, but if necessary:
1.
1.
Connect the Power Cord located on the bottom side of the
scale.
scale.
2.
Follow Daily Steps 1 through 3.
3.
Set the Date & Time if necessary (see next page).