Zebra Technologies TTP 7030 Manuel D’Utilisation
11
Product Presentation
Indicators
10/05/2009
TTP 7030™ Technical Manual
P1003636-002
Indicators
Status Indicator
The status indicator (see
functions:
Error-codes are reset:
• When the conditions causing them are removed.
• When the printer is turned off/on.
• When the
blue
printhead release arm is lifted and then lowered.
Control Board Indicators
The control board has two power indicators behind the power connector:
• Green indicator constantly ON: 24 V present
• Red indicator constantly ON: 5 V OK (generated on control board)
ON constantly
Indicates that the printer is operational.
Flashes, pauses, flashes
Indicates warnings of non-severe error. The number of flashes
reflects the warning-code:
reflects the warning-code:
•
2 flashes: Paper low
Note •
This signaling is disabled by default. It can be
disabled/enabled by setting parameter P52.
•
3 flashes: Weekend low
Warning-codes are reset automatically when the condition
causing them are removed.
causing them are removed.
Flashes rapidly
Indicates severe error. Hold down the Feed button and the
number of flashes will reflect the error-code.
number of flashes will reflect the error-code.
•
1 — Presenter jam, paper cannot be ejected / retracted
•
2 — Cutter cannot return to home position
•
3 — Out of paper
•
4 — Printhead lifted
•
5 — Paper wrapped around platen (under head)
•
6 — Temp error >60
°
C
•
7 — Presenter jam, motor cannot rotate
•
Fast flashes — Checksum error, firmware
•
Steady light — Wrong firmware type