Zebra Technologies TTP 7030 Manuel D’Utilisation
87
Page Setup
Aligning Preprint And Thermal Print
10/05/2009
TTP 7030™ Technical Manual
P1003636-002
Aligning Preprint And Thermal Print
The printer can synchronize the cutting of the printout with black-marks printed on the back of
the paper. Use this function when you have preprint on the media and you don't want a cut in
the middle of that preprint, or text printed on top of the preprint.
the paper. Use this function when you have preprint on the media and you don't want a cut in
the middle of that preprint, or text printed on top of the preprint.
The sensor used to detect the black-marks is the same sensor as used for paper end detection. It
is positioned 9 mm from the edge of the paper on the side of the
is positioned 9 mm from the edge of the paper on the side of the
blue
release arm, and 25 mm
behind the cutter (as seen from the presenter [output] side of the printer). The sensor accuracy
is about ±0.5 mm so avoid designing printouts with too high demands for synchronization.
is about ±0.5 mm so avoid designing printouts with too high demands for synchronization.
Figure 22 • Recommended black mark size and position
The sensor triggers on the black-to-white transition of the black-mark, which is when the black
print ends (trailing edge).
print ends (trailing edge).
Cut line
Paper viewed from
inner side (opposite
to thermal-coating side)
inner side (opposite
to thermal-coating side)
SW95001B
Cut line
Paper
feed
direction
25 mm
Black mark size 5 x 9 mm
75 mm
25 mm
9.1 mm
Punched hole 5 mm
Preprinting not
recommended
within this zone
recommended
within this zone