Zebra Technologies 3ULQWHUV Manuel D’Utilisation

2

 Zebra 

XiIIIPlus Users Guide

Unpack and Inspect the Printer

Make sure the printer is in good condition when you receive it. The instructions below 
outline what you need to do.

Use this list as a guide to inspect the printer.

‡ Check all exterior surfaces.
‡ Raise the media access door and inspect the media compartment.
‡ In case shipping is required, save the carton and all packing material. Contact your 

authorized Zebra reseller for instructions.

‡ A power cord may or may not be included. If one is not included, or if the one 

included is not suitable for your requirements, see 

If you discover shipping damage:

‡ Immediately notify the shipping company and file a damage report with them. 

Zebra Technologies is not responsible for any damage incurred during shipment of 
the equipment and will not repair this damage under warranty.

‡ Keep the carton and all packing material for inspection.
‡ Notify your authorized Zebra reseller.

If you are not placing the printer into operation immediately, repackage it using the 
original packing materials. The printer may be stored under the following conditions:

‡ Temperature: –40° to 140° F (–40° to 60° C)
‡ Relative humidity: 5% to 85% non-condensing

For personal and equipment safety, always use an approved three-

conductor power cord specific to the region or country intended for installation. 
This cord must utilize and IEC-320 female connector, and the appropriate region-
specific three-conductor grounded plug configuration.