Zebra Technologies 3ULQWHUV Manuel D’Utilisation

Print Mode Choices

Zebra XiIIIPlus Users Guide 

33

Rewind Mode and Peel-Off Mode use the rewind spindle. Label liner must be 
removed every time you change labels for the printer to work correctly. 

Unwind approximately 36 in. (915 mm) of liner from the rewind spindle. Cut it off 

at the spindle.

Pull out the hook. Slide the liner off of the rewind spindle and discard.

Wind the labels around the rewind spindle once or twice, then reinstall the hook. 

Continue winding to remove any slack in the labels. 

Fanfold labels feed through either the bottom or rear access slot from outside the 
printer. The media hanger or media supply spindle are not used with fanfold labels.

Rewind spindle

Guide plate

Spindle hook

Rewind plate

Cutter 

It is not necessary to turn off the power to remove liner from the 

rewind spindle. If power is turned off, all label formats and images, as well as any 
temporarily saved parameter settings stored in the printer’s internal memory, are 
lost. When power is turned back on, these items must be reloaded.

If the labels have not run out, you must cut the label liner at the spindle.