Kodak 8660 Manuel D’Utilisation

 

Installing the Hardware

 

Part No. 6B4389

June 1999 

2-7

 

To connect the NIC to a 10baseT or 100baseTX Fast Ethernet 
network, you need a 10 or 100 MB capable Ethernet hub/switch 
with at least one unused port installed on your network and an 
appropriate length of RJ45 modular cable. Category 5 cabling is 
necessary for 100 MB operation.

1. Connect one end of the RJ45 network cable to the Ethernet 

port on the NIC.

2. Connect the other end of the RJ45 network cable to the 

Ethernet port on your hub or switch.

The NIC automatically senses if it is connected to a 10BaseT or a 
100BaseTX network.

 

You need to print a test page to verify that the NIC is installed 
correctly. Use the test button on the NIC face plate to make a test 
print. The test button is located between the Ethernet port and the 
serial port.

NOTE: The test button is also used to reset the NIC to factory 

defaults. Press the switch, and hold it in for at least 5 
seconds to reset the NIC to factory defaults.

To print a test page:

1.  Make sure that the printer is connected to a functioning 

network. If the NIC does not detect protocols such as 
AppleTalk, it automatically disables that protocol.

2. Turn on the power to the printer.

3. Locate the test button on the NIC faceplate.

o o o o o

o o o o