Lenovo 4083 Manuel D’Utilisation
Figure 52. Removing the heat sink and fan assembly
5. Place the new heat sink and fan assembly into position and lower the lever to secure the heat sink
and fan assembly.
6. Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system board.
Replacing the microprocessor
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait
three to five minutes to let the computer cool before opening the computer cover.
To replace the microprocessor:
1. Open the computer cover. See “Opening the computer cover” on page 107.
2. Pivot the drive bay assembly upward to gain access to the system board. See “Accessing the system
3. Locate the heat sink and fan assembly and disconnect the heat sink and fan assembly cable from the
microprocessor fan connector on the system board. See “Locating parts on the system board” on
page 110.
page 110.
4. Remove the heat sink and fan assembly. See “Replacing the heat sink and fan assembly” on page 117.
118
ThinkCentre Hardware Maintenance Manual