Lenovo 10AB Manuel D’Utilisation
7. Align the hole
1
in the new power switch board with the tab
2
on the computer and position the new
power switch board onto the chassis. Then, install the screw to secure the new power switch board
on the chassis.
on the chassis.
Figure 48. Installing the power switch board
8. Connect the power switch board cable to the power switch board cable connector on the system board.
9. Reinstall the hard disk drive assembly. See “Installing or removing the hard disk drive assembly”
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 78.
Replacing the Wi-Fi card module
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
This section provides instructions on how to replace the Wi-Fi card module.
Note: The Wi-Fi card module is only available in some models.
To replace the Wi-Fi card module, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 53.
Chapter 5
.
Installing or replacing hardware
61