Brady 2034 Manuel D’Utilisation
_______________________________________________________________________
34
34
Using Your Printer
The Self-Test may also be initiated while the power is on by simultaneously
pressing the PAUSE and CANCEL buttons. Simultaneously release them and
immediately press and hold the FEED button until the ribbon/media LED
flashes.
pressing the PAUSE and CANCEL buttons. Simultaneously release them and
immediately press and hold the FEED button until the ribbon/media LED
flashes.
NOTE:
If any configuration errors are indicated by the Self-Tests, check the
Printer's dip switch settings or configuration setup.
Printer's dip switch settings or configuration setup.
3.3.1 Test Label Examples
The first test label printed will be the Configuration Label, this label lists the
Printer's configuration and status. The following sample was produced on a
standard printer without the test plugs installed.
Printer's configuration and status. The following sample was produced on a
standard printer without the test plugs installed.
FRI
SEPTEMBER
23,
1996 10:12 340
VER:
G
A
-
1.14
01/30/96
ROM
CHECKSUMS
U13
47-2091-01
P
U24
47-2090-01
P
U34
47-2088-01
B
U2
47-2089-01
B
SYSTEM RAM CHECKS
_ _ _ _
GOOD SYSTEM RAM SIZE
_ _
512 KBYTES
SERIAL PORT BAUD RATE IS 9600
TRANSFER SWITCH IS ON
SWITCH 1
1
2
3
4
5
6
7
8
ON ON
ON OFF OFF OFF OFF OFF
INTERNAL
1
2
3
4
5
6
OFF OFF OFF OFF OFF OFF
I
NPUT VALUES
PAPER: 255
EDGE: 253 REFL: 0 TEMP:
76
POT : 120
TOFA:
120 RIBN:
10 RWND:
0
COUNTER INFORMATION
ABSOLUTE VALUES 2-21-1996
RESETABLE VALUES 9- 5-1995
LENGTH
_ _ _ _
2317 INCHES
LENGTH
_ _ _ _
2317 TIME
_ _ _ _
_ _
1 HOURS
TIME
_ _ _ _ _ _
1 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE
_ _ _ _ _ _ _ _
15
SCALABLE FONTS
_ _ _ _ _ _ _ _
0
Figure 3-4 Configuration Test Label