Fujitsu BS2OSD Manuel D’Utilisation
![Fujitsu](https://files.manualsbrain.com/attachments/6c4642b33d2edbd09f94719c20a133aa0e862902/common/fit/150/50/80a45702a21fefb1823bce6851e87db450dccf7792cb572ebc8a90330a68/brand_logo.png)
Page 19
*4
Dynamic I/O load distribution for disks on the FC channel of
*4
the S server (DPAV)
*4
Only one I/O can be executed at any particular time on a disk.
*4
If several applications with a large number of I/Os use the same
*4
disk, this can lead to high wait times.
*4
Until now, static PAV (Parallel Access Volume) has been used on
*4
S servers since BS2000/OSD-BC V5.0 to alleviate this problem.
*4
The function allows multiple concurrent accesses to one logical
*4
device.
*4
With PAV, several device addresses (alias devices) are assigned
*4
to one logical (base) device on the same controller, thus
*4
allowing multiple I/O orders to be started concurrently via
*4
the base and alias devices.
*4
PAV on the FC channel is a pure software solution that can be
*4
operated without intervening in the Symmetrix controller. To do
*4
this, BS2000 uses the fact that disks on the FC channel can
*4
still accept I/O orders if an I/O is already active.
*4
Static PAV assigns the alias devices statically to the base
*4
device and therefore requires predictive planning of device
*4
utilization.
*4
Dynamic PAV (IORM DPAV function) assigns the alias devices
*4
autonomously to the volumes that would profit most from them.
*4
For devices connected via type FC, DPAV switches an alias
*4
device from the current base device to another base device by
*4
dynamically changing the I/O configuration.
*4
In VM2000 operation, DPAV must be activated for each guest
*4
system in which DPAV is to be active.
*4
Note: /START-VM cannot be used during dynamic I/O configuration
*4
changes on S servers while operating under VM2000.
*4
When using the IORM DPAV function, dynamic I/O reconfiguration
*4
can be called at any time, thus disrupting /START-VM
*4
For this reason, as of VM2000 V9.0 with /START-VM and active
*4
dynamic I/O reconfiguration the system waits a maximum of 15
*4
seconds for the I/O reconfiguration to be completed. If the I/O
*4
reconfiguration takes longer, /START-VM is rejected.
*4
The following restrictions apply when using HIPLEX AF under
*4
VM2000 < V9.0:
*4
- If the "warm standby" scenario is used, the DPAV function must
*4
be deactivated on all virtual machines of the standby system.
*4
- When monitoring the guest system with VM2000 resources via the
*4
live monitor while using DPAV, RESTART-AFTER-STOP=*NO must be
*4
set in the ADD-VM2000-MONITORED-SYSTEM statement.
*4
Optimized load distribution in CentricStor operation (DDAL)
*4
This function can be activated but the controlling intervention
*4
will only be implemented in future BS2000/OSD-BC versions. DDAL
*4
must be activated on all guest systems and the monitor system
*4
for IORM to be able to take control in VM operation.