Epson 320SX PLUS Manuel D’Utilisation

The SIMM should snap into place between the tabs and

the retaining posts. If it does not go in smoothly, do not
force it; pull it all the way out and try again.

Make sure the SIMM is fully inserted into the socket and
that the pins on the retaining posts extend through the
holes in both ends.

5. Repeat steps 3 and 4 for each SIMM you want to install.

6. Replace the subassembly and cover as described in

Chapter 5.

7. Then see “Post-installation Setup” on page 6-25 for

instructions on configuring your computer for use with

your new memory.

If you need to remove memory modules from your computer,

have your dealer do it for you or follow the steps below. If

you remove them yourself, check the table on page 6-15 to be

sure you remove SIMMs from the correct sockets.

It is safer to have your dealer remove SIMMs for you since

there is a danger of transmitting an electrostatic discharge

and damaging your components.

1. Remove the computer’s cover and subassembly as

described in Chapter 5.