Epson 286 PLUS Manuel D’Utilisation

The instructions in this appendix describe how to install and
remove optional Epson diskette and hard disk drives. All drives

sold by Epson for the Equity 286 PLUS are qualified and
recommended for use in this system. Your drive may look a bit

different from the one illustrated in this appendix, but you

install it the same way.

If you are installing or removing a non-Epson drive, some of the

steps in this appendix may not apply to your drive; see the
documentation that came with it for more information.

Each section describes a part of the process you may need to

perform. Here are the guidelines:

Before you begin any of the procedures described in this
appendix, follow the steps in Chapter 5 to remove the
computer’s cover.

If you are removing your only hard disk drive, see “Removing

a Hard Disk from the Vertical Position” on page B-24.

If you are installing a hard disk drive or removing one and
leaving another in the computer, follow the steps under
“Setting the Hard Disk Drive Jumpers” on page B-4 first.

If you are installing or removing a diskette drive and there is
a hard disk drive installed in the vertical mounting position,
see “Removing a Hard Disk from the Vertical Position” on
page B-24.

If you are installing or removing a diskette drive and there is

no hard disk drive installed in the vertical mounting

position, see “Installing or Removing a Disk Drive in the

Horizontal Position” on page B-27.

Additional instructions in each section tell you which steps to

perform next.

Installing and Removing Disk Drives

B-3