Epson 286 PLUS Manuel D’Utilisation

If one of your hard disk drives is already installed in the

computer, follow the steps under “Removing a Hard Disk From

the Vertical Position” on page B-24 to remove it. Then set the

jumpers on both drives while they are out of the computer. The

steps in that section tell you which instructions to follow next.

Note

If you are removing one hard disk drive and leaving one in
your computer, be sure to set the jumpers on the remaining

drive to indicate that you have only one hard disk drive. See

the table above for the jumper settings. Then follow the

instructions under “Removing a Hard Disk From the Vertical

Position’ on page B-24 so you can access the jumpers on the

dr i v e .

Follow the instructions in this section to install (or reinstall) a
hard disk drive in the vertical mounting position. You may need

to perform the following procedures:

Remove the mounting frames from a new hard disk drive

Remove the mounting plate from the computer and connect

it to the drive

 Install the drive

Connect the drive and power cables.

If you are installing a new drive in the vertical mounting

position, you should follow all of the steps in this section. If you

are reinstalling a drive that you previously removed from this

position, see “Installing the Drive” on page B-12.

Installing 

Removing Disk Drives

B-7