Epson 286 PLUS Manuel D’Utilisation

Follow these steps to lift up the subassembly and connect the

drive cable to the main system board:

1.

Remove the front panel from the computer by lifting up

slightly on the three clips at the top of the panel and tilting

it toward you. Then set it aside.

clips

front panel

2.

To lift the subassembly from the front of the computer,

place your thumbs under the diskette drive and grasp the top
edge of the computer with the rest of your fingers, as shown

in the following illustration. (If you have a diskette drive
installed in the lower horizontal drive bay, place your

thumbs underneath that drive instead.) Then lift up the

subassembly with your thumbs.

B-18

Installing and Removing Disk 

Drives