Epson 286 PLUS Manuel D’Utilisation

When the system has successfully completed its self test, you see

the following prompt:

Press <Del> to start SETUP

Do not press any key yet. If MS-DOS has already been installed

on your system, you’ll see a prompt to enter the date. (For

information about loading the operating system, see your

MS-DOS Installation Guide or Reference Manual.)

If there is no operating system on your computer, you see an
error message. Ignore the message for now. Follow the

instructions below to turn off the computer and then go on to

Chapter 2 for instructions on running the SETUP program.

If your computer’s configuration does not match the

information stored in the computer’s CMOS RAM (defined

through the SETUP program) you see an error message and a

prompt to press the 

F1 

key. Press 

F1 

to continue. You need

to run the SETUP program to correct the information. See

Chapter 2 for instructions.

When you are ready to turn off your system, reverse the

sequence of steps you followed to turn it on. Turn off the

computer first, then turn off the monitor and any peripheral

devices.

Now go on to Chapter 2 and follow the instructions to run the

SETUP program.

1-18

Setting Up