Epson 286 PLUS Manuel D’Utilisation

MS-DOS expects the computer to have at least two diskette

drives and displays prompts and messages accordingly. Usually,

MS-DOS recognizes the first diskette drive (the top drive) as A
and a second diskette drive as B. If you have only one diskette
drive, MS-DOS can treat it as both A and B when you need to
perform operations that normally require two diskette drives.

For example, if you enter a command to copy data from A to B,
MS-DOS copies the data from the first diskette you place in the

drive (which would be drive A) to the computer’s memory.

Then MS-DOS prompts you to insert another diskette (for drive

B) and copies the data from memory to the new diskette. When

copying is complete, you see a prompt to insert the original

  diskette (A).

Because you may often swap diskettes this way, it is important to

remember which diskette is which. It is also a good idea to write-
protect your original diskette. See “Write-protecting Diskettes,”

above.

If you have a hard disk and one diskette drive, you can load the

operating system and application programs from the hard disk,

create and store your data there, and use the diskette drive just

for copying data to or from diskettes.

However, if you have only one diskette drive and no hard disk,
you need to use that drive to load the operating system as well as

any application program you are using. First, insert the operating
system diskette (the Startup diskette, for example) in drive A
and load the operating system; this copies it to the computer’s
memory (RAM) so you do not need to leave the system diskette

in the drive. Then remove the system diskette and insert your
application program diskette to load that data into memory, too.

See your application program manual for detailed instructions.

Using Your Computer

3-15