Emerson RTM-ATCA-7350 Manuel D’Utilisation

The GE daughter card provides the network port indicators and the FC daughter card provides 
the FC status indicators. You can monitor these indicators to diagnose the current status of 
RTM-ATCA-7350.

The following table lists the indicators on the RTM-ATCA-7350 face plate.

Table 3-1 Indicators on the RTM-ATCA-7350 Face Plate

OOS

Red or amber

Service status 
indicator

z

The RTM-ATCA-7350 turns the red LED on 
when transitioning from FRU M3 to M4 
state if in local control state. It is the 
responsibility of the application to change 
the status of the LED via IPMI command.

z

The RTM-ATCA-7350 turns the LED off 
when transitioning from FRU state M6 to 
M1 if in local control state.

IS

Red, green or 
amber

In service indicator

The IS LED is off  when the payload processor 
starts running.

Payload Management software is

responsible for controlling the IS LED.

H/S

Blue

Hot swap indicator

z

Off: RTM-ATCA-7350 is in activated state.

z

On: RTM-ATCA-7350 is inserted, but in 
deactivated state or not powered on.

z

Blinking at the long blink rate

1

: RTM-ATCA-

7350 is requesting activation.

z

Blinking at the short blink rate

2

: RTM-

ATCA-7350 is requesting deactivation.

1. Blinking at the long blink rate means that the indicator is on for 900 ms and then off for 100 ms alternatively.

2. Blinking at the short blink rate means that the indicator is on for 100 ms and then off for 900 ms alternatively.

ATN

Amber

Attention indicator

The ATN LED is set to off when the payload 
processor starts running.

Payload Management software is responsible 
for controlling the ATN LED.